|
Post by clarky on Dec 12, 2007 21:25:00 GMT
hi is the primmy et3 crank cone size the same as ets ?im putting ets engine in my primmy et3 and dont want to fuck about with the electrics as it will evenually go back in ets(probably 10 years time the way things are going)so was just going to swap over stators and flywheels and bieng lazy didnt want to find out myself by trying them .If theyare different sizes do you think the ets flywheel will work ok over the et3 stator.Also have a dr 133 kit on it and read somewhere to set timing to 16 degrees is this correct ?its just bolted on with standard crank/carb and crankcase transfers not matched.And what is the standard ets timming figure when marks lined up(stator to crankase)thanks clarky.
|
|
|
Post by Juan on Dec 12, 2007 22:53:47 GMT
Hi and welcome. The cranks are totally differant,the ET3 uses a 19/20mm job and the ETS a 24/25mm item so you're not swapping stator or flywheel.The easiest way is just to swallow it and change the loom.
|
|