|
Post by hank on Nov 23, 2007 21:00:29 GMT
two pics of my new headset - just checking whats missing. Obviously the rollers that are clipped on the end of the tubes - do they have a sleeve that fits over the tube or is that a seperate part? the plastic cables guide seems to be ok, dont know what that metal bracket is though finally, i know this has been asked recently, but where do the two (?) headlight springs fit?
|
|
|
Post by unreliablesc on Nov 24, 2007 10:34:44 GMT
two pics of my new headset - just checking whats missing. Obviously the rollers that are clipped on the end of the tubes - do they have a sleeve that fits over the tube or is that a seperate part? the plastic cables guide seems to be ok, dont know what that metal bracket is though finally, i know this has been asked recently, but where do the two (?) headlight springs fit? The bracket could be a homemade stop for the throttle. take your picture from this angle and then we could show you where the springs should sit.
|
|
|
Post by hank on Nov 24, 2007 20:39:15 GMT
i presume its that little cutout behind where the tube goes through. doesnt look quite the same on the other side. is there two or just one spring?
|
|
|
Post by unreliablesc on Nov 24, 2007 22:56:57 GMT
i presume its that little cutout behind where the tube goes through. doesnt look quite the same on the other side. is there two or just one spring? Yes, hooks on here, on spiring on each side. don't know why it's different on the right side, could be worn by a loose vibrating spring perhaps?
|
|