Post by joshpsmsc on Nov 14, 2007 18:39:24 GMT
Hello all,
I am getting ready to fit a Zirri short 4th into my gearbox. Is there anything I should take into consideration while doing this? I've been told to flip gears around to make it work, and that the shim closes to the small bearing in the case will need to be really thick. I am trying to close the gap between third and fourth gears. The new set up will be:
Ported Malossi 136 (134)
Malossi Case Inducted Reed
Vforce 3 Reed Cage
Mikuni TM24
JL Pipe
20/20 Mazzi Cut Crank (I know this doesn't matter much)
Ported Cases removing the rotary lip and opening the intake, transfers
8% Upgear kit.
What do I need to do to properly fit the Zirri short 4th? Will it help my scooter at all.
I am getting ready to fit a Zirri short 4th into my gearbox. Is there anything I should take into consideration while doing this? I've been told to flip gears around to make it work, and that the shim closes to the small bearing in the case will need to be really thick. I am trying to close the gap between third and fourth gears. The new set up will be:
Ported Malossi 136 (134)
Malossi Case Inducted Reed
Vforce 3 Reed Cage
Mikuni TM24
JL Pipe
20/20 Mazzi Cut Crank (I know this doesn't matter much)
Ported Cases removing the rotary lip and opening the intake, transfers
8% Upgear kit.
What do I need to do to properly fit the Zirri short 4th? Will it help my scooter at all.