|
Post by motovespa on Oct 1, 2007 8:03:17 GMT
After pulling the barrel off my spanish primmy I was quite chuffed to find it was an Autisa kit and not a standard barrel.
Does anyone have any info on these?
It's an alloy barrel with an iron liner, the piston has two rings, the top one being very close to the top of the piston (Does that make it high compression?) - It looks to me like a 75cc barrel or somewhere in that ballpark, definetely much smaller than a 125 barrel.
The only thing I've found on the net about them is they were made in Spain during the 80's.
Cheers, Rog
|
|
|
Post by Juan on Oct 1, 2007 17:47:09 GMT
I've never heard of an Autisa smaller than 125,BarneySt.George runs one.
|
|
|
Post by barneystgeorge on Oct 8, 2007 19:30:56 GMT
only ever seen 125 cc if your scoot is a primmy it should be a 125 barrell worthless i will take it off your hands ;D ;D ;D or 5 mii of base 2 off top and cr125 piston to match[cut window in right side]std piston 56 mm on autisa
|
|
|
Post by motovespa on Oct 9, 2007 8:24:02 GMT
My Primmy is a Spanish 75cc one so wouldn't have had a 125cc barrel as standard.
The Autisa barrel is 100% not a 125cc barrel, after doing a bit of searching on the yahoo smallframe group, it looks like it might be a 105cc kit. They reckon it's one of the best kits to put on the really early smallframes where you can't easily fit a 125cc barrel on it.
I did a quick measurement of the piston and it looked like 51mm (although I'm not 100% if I measured it correctly!)
|
|