|
Post by breezer on Sept 11, 2007 19:13:01 GMT
...never had a 50 or owt smaller than a 125. I'm looking for a project bike for a cut-down and it will probably be one of the smaller engined bikes, pk50 or v90 / 100 summat like that.
My question is can I put a 125 top end on one of these smaller engines?
Is it a case of changing the crank?
Owt else I may need to consider with regard to which engine would be the easiest to convert?
Ta
|
|
|
Post by adspeed on Sept 11, 2007 19:42:29 GMT
Yes you can.....my Parma is on a 90 casing. An expensive bearing is required for the bigger cranks....about 50 sheets. The inlet seems smaller on the little casings but fine if you go for reed barrel... ;D
|
|
|
Post by breezer on Sept 11, 2007 21:27:36 GMT
Cheers Ad
|
|
|
Post by MiNiKiN on Sept 12, 2007 9:53:10 GMT
Please avoid northern dialect (owt , ta) and do not cut a v90/v100.
Ta ;D
|
|
|
Post by breezer on Sept 12, 2007 11:12:38 GMT
Would only cut a 90 etc if it was a bit rough, and not good enough to tidy up. or, to put it another way... tha nos if it were reet enuff ah wunt currit. PKs though...
|
|
|
Post by hank on Sept 12, 2007 13:57:45 GMT
PKs though... By ‘eck, thi can't doo that
|
|
|
Post by fredperry2 on Sept 12, 2007 18:04:50 GMT
i got a cutdown vespa 50N cut right down to the horncasting on the front....gonna be great..! ;D
|
|
|
Post by Juan on Sept 13, 2007 17:17:27 GMT
My first 90 was like that.
Mmmmmm...................skellies. ;D
|
|