|
Post by hanlia1888 on Nov 25, 2009 19:25:48 GMT
hi all just bought a px125(166) was spluttering a bit so checked the main jet (115) which is about right. took the plug out all black and oiling so running to rich took a while to find adjusting screw but what is the secret to getting your hand in or a spanner to adjust it as there is not much room ...many thanks ps.this is my first lardy as i do prefer my smally v100(135)
|
|
|
Post by thedarklord on Nov 26, 2009 10:11:48 GMT
hi mate just put a screwdriver thought the access hole at the back of the air filter casing and you should be able to turn it then.
|
|
|
Post by tomdavid1988 on Nov 26, 2009 11:12:18 GMT
what pipe are you running with ? I ran mine on 112 IIRC. It's your starter motor that is in the way, I usually take these off but have found from working on other people scoots the best way to do it is by removing rear wheel and going in from there. If it's electric start model it should be hex head not screw shouldn't it
|
|
|
Post by hanlia1888 on Nov 26, 2009 15:34:49 GMT
hi mate yes it has the hex head bolt and its a nightmare to get to adjust surely ther must be an easy way to adjust it ...many thanks
|
|
|
Post by hanlia1888 on Nov 26, 2009 15:37:07 GMT
hi me again yes it has electric start and simonni exhaust...thanks
|
|