No go....

[unreliablesc]

I was going to start the Primmy for the first time today....

Checked for spark.... no spark
Checked with 4 different plugs... no spark
Disconnected all wires going to the loom... no spark
Checked the wires to the CDI, cut 2 cm off and new cable shoes... no spark
Cut 1 cm of each end of the spark plug cable... no spark
Tried the CDI from the VNB... no spark

The flywheel puller was back at my place, so i wasn't able to take look at the stator.

CDI is new
Pickup is new
New spark plug cap and cable

So, I'm bloody angry right now, the first time i build a scooter with parts I know is good, and no joy...

Any tips on what to check next?

[Juan]

Totally dead?I can only presume it's time to whip the flywheel off.

But then I'm worse with electrics than refusing beer from women in low cut tops. ;D

[unreliablesc]

admin said:

Totally dead?I can only presume it's time to whip the flywheel off.

But then I'm worse with electrics than refusing beer from women in low cut tops. ;D

Yeah, as dead as yours truly on a Sunday morning

I can normally work my way around electrical troubles, but statorprobles ain't my game...

I was so pissed i had to go for a ride on the VNB ignoring any run-in advice...

[MiNiKiN]

Did you try to disconnect the cable leading from the CDI to the short circuit stop button (usally the outer green one)? Maybe the stop button @ the lightswitch is fucked

[unreliablesc]

Yep, that problem is eliminated.