|
|
Post by atufte on Feb 18, 2007 15:52:27 GMT
Does anyone know how to mount the seat cushion to the carbon part of the seat? I see there are bolts under the cushion, but there are no holes or fittings on the carbon part (the seat)
Thanks in advance...
|
|
|
|
Post by hank on Feb 19, 2007 10:53:11 GMT
I think you just have to glue them on  |
|
|
|
Post by atufte on Feb 19, 2007 11:26:04 GMT
Ok, but why are there bolts mounted under it, (the seat cushion) then i will have to remove the bolts and then glue it on, sounds very strange??? ( and to remove the bolts i have to totally take the cushion apart, because the bolts are mounted inside facing out underneith the cushion...)
|
|
|
|
Post by hank on Feb 19, 2007 11:36:43 GMT
velcro? maybe that would be too easy to steal or it may not stay on securely. I suppose screwing or bolting it on would spoil the look, someone must know? loads of scooters with them on.
|
|
|
|
Post by Juan on Feb 19, 2007 18:03:34 GMT
Oz had one on his PTS1E,perhaps he'll chime in here.
|
|
|
|
Post by atufte on Feb 19, 2007 19:58:32 GMT
Oz had one on his PTS1E,perhaps he'll chime in here. I hope he does... |
|
|
|
Post by Juan on Feb 21, 2007 20:56:17 GMT
Copied from SBW.
I use black hi density foam, it's waterproof so you only surface dampness. I use Duck double sided carpet tape to fit it. I used to use bostick glue but that is a pig to clean off if you change the paint or pad, tape is much better.
I get mine from garden centre/plant stalls in sheets big enough to use as a double ground sheet, but i have seen good stuff in camping shops as ground mats, depends what colour you want.
|
|
|
|
Post by atufte on Feb 21, 2007 21:42:08 GMT
Thanks, i took out the fitted screws and used a silicone like glue, works like a charm.... :-)
|
|
