|
Post by smallyshane on Feb 6, 2007 12:51:05 GMT
Hi All, I have an ET3 currently running it with polini 130, 24mm PHBL delly, Maz crank, PM40 pipe, and the cases matched to the kit. Would I be looking at getting part no.21501150 link fixed should I wish to go down the reedvalve route? Would this be a suitable upgrade for my setup and What kind of differences in performance could I expect? I suspect that it would largely be more torque than anything, but would I get much in the way of extra acceleration (probable due to extra torque) or top end (not sure about this...) Cheers
|
|
|
Post by Juan on Feb 6, 2007 17:53:50 GMT
TBH you won't get a huge performance boost.Also the Polini RV manifolds are a bit rubbish,if you're adament to take this route then look at the Malossi alternatives.
|
|