|
Post by 64treefrog on Dec 17, 2006 16:09:01 GMT
Hi, new to scooters, can anyone tell me how to make the electrics on my 76 primmy 12 volts? I have been on web sites and it seems I would have to fit stator and flywheel from et3 or an aftermarket electronic ignition kit! Any comments and advice welcome, come on guys someone out there has done it..... Cheers
|
|
|
Post by barneystgeorge on Dec 17, 2006 17:16:53 GMT
not quite that simple the way i do it is new loom from beed speed p range brakelight switch ,coil,cdi,rally dc light switch[if u can find one]et3flywheel stator or if rebuilding engine change crank 2 fat type+pk flywheel+stator 80w
|
|
|
Post by Juan on Dec 18, 2006 16:59:23 GMT
Just a point on the flywheel here.I've used old points type on electronic P ranges before with no prolems before so you might not need that.
Depends on what you want to do but if you follow Barney's method you won't go far wrong.
I would suggest using Piaggio part though,I've yet to hear a good report on the Variotronic kits.
If you're going with an all new system I would use an ETS/XL crank,converson bearing,stator,flywheel and all the other assorted electrical gubbins.
|
|