|
Post by keeperlit8 on Apr 25, 2021 19:51:08 GMT
Hi got a primmy that i am fitting a polini kit. So far i have got the kit A ets crank A bgm pro banana pipe The large taper flywheel New seals gaskets and bearings Was going to match the barrel to the casings. Few questions Will the 19 carb be ok or best to go 24mm Will a 4 plate clutch do fine. Just looking for a bit more power Built for all round work
|
|
|
Post by jbcollier on Apr 26, 2021 1:18:50 GMT
The 19/19 works very well. The 24 has more potential if you go further. I have done lots of Polini + 19/19 conversions and they work great. I also fit 90/100 primaries. Makes for a fast, zippy scoot that can pull 4th on many hills and out run a stock P200, no problem.
|
|
|
Post by keeperlit8 on Apr 26, 2021 15:45:51 GMT
Thanks for that. Will see how it runs on 19 mm first then think about going to 24
|
|
|
Post by keeperlit8 on Apr 28, 2021 20:46:39 GMT
Been looking at 24 mm carbs. I see the polini is a copy of the pwk. Any one tryed the pwk copys from China
|
|