|
Post by madmax on Aug 5, 2020 18:51:19 GMT
Quattrini suggest loctite 510, however, you can use treebond or any good gasket sealants.
|
|
|
Post by pugwash on Aug 5, 2020 19:13:05 GMT
The 510 loctite works, I prefer using that on the cylinder head gasket face instead of threebond.
|
|
|
Post by quat444 on Aug 6, 2020 15:08:14 GMT
Sorry, should have been clearer. My question was how to deal with the heat in the case using Henri's method, when using 3Bond or 510 loctite. Wont it get cooked off?
|
|
|
Post by pugwash on Aug 6, 2020 16:31:15 GMT
Threebond 1184 synthetic rubber
Application areas include sealing transmission case covers, motorcycle cases, timing chain cases, side covers, 2-piece cylinders, clutch housing bolts, automotive, outboard, oil filter mounting surfaces and virtually every other automotive need. Since it excels in padding properties, it is highly effective in sealing surfaces with poor flatness or large gaps and Metal on metal joints.
The above is Copied and pasted from threebonds webpage. It doesn't seem to burn off at all when used as a head sealant. But it's much harder to remove than the 1215 Threebond which is a silicone sealant. And the 1184 seems to be more stable where petrol is in contact.
|
|
|
Post by tzsteve on Aug 7, 2020 14:36:39 GMT
I use threebond on my TZR crank case, And just about anything on the smallie except the head and exhaust slip joint
Good stuff, oil resistant when cured and aluminium coloured
|
|
|
Post by quat444 on Sept 22, 2020 14:09:41 GMT
Next query: There’s a fair size difference between the intake pipe and the recommended vhst carb outlet.
Can anyone point to a rubber manifold that will fit between the two?
|
|
|
Post by madmax on Sept 22, 2020 18:43:39 GMT
Next query: There’s a fair size difference between the intake pipe and the recommended vhst carb outlet. Can anyone point to a rubber manifold that will fit between the two? You can use lambretta one For TS1/RB manifold if I remember correctly. Here you go: link
|
|
|
Post by quat444 on Sept 27, 2020 12:17:30 GMT
Next query: There’s a fair size difference between the intake pipe and the recommended vhst carb outlet. Can anyone point to a rubber manifold that will fit between the two? You can use lambretta one For TS1/RB manifold if I remember correctly. Here you go: link Cheers! Even found one here in Oz.
|
|