|
Wanted
Oct 24, 2011 11:55:38 GMT
Post by coddy on Oct 24, 2011 11:55:38 GMT
I am after a set of 27 69 primary's and a reedvalve for me 135. Or will a set of primmy ones do
|
|
|
Wanted
Oct 25, 2011 13:34:45 GMT
Post by jonnysnatchsniffer on Oct 25, 2011 13:34:45 GMT
primmy primarys will be fine the 27/69 are a slightly lower ratio but i doubt you would notice, the advantage of the 27/69 is that the 27 can be changed with drt ones so the ratio can be changed easilly using 26 or 28 or 25 whats up with the rotary ?
|
|
|
Wanted
Oct 25, 2011 17:09:52 GMT
Post by coddy on Oct 25, 2011 17:09:52 GMT
Ok will use primmy primary's would you use a short 4th. The sealing pad has had it
|
|
|
Wanted
Oct 25, 2011 19:22:36 GMT
Post by daisyb on Oct 25, 2011 19:22:36 GMT
Got a 2 stud Polini reed manifold, V good condition just dusty, don't think it spent more than 10 mins on an engine. £40 + post?
|
|
|
Wanted
Oct 25, 2011 20:13:39 GMT
Post by coddy on Oct 25, 2011 20:13:39 GMT
Does the carb clamp on or use a rubber mate
|
|
|
Wanted
Oct 26, 2011 11:52:50 GMT
Post by daz on Oct 26, 2011 11:52:50 GMT
Afternoon Coddy
I have a 2 stud Malossi reed block, will need a set of gaskets and a rubber mount with clips.
This is for crank case fitting not the direct version for the cylinder.
Bought for £55.00 from Smallyshane off this forum.
Daz.
|
|