|
Post by scotia on Sept 19, 2011 11:48:08 GMT
hi guys (and a girl now apparently ;D) does anyone have a cdi bracket that they could trace round for me so i can knock one up also looking for an out line of a floor mat (just the sides centre not needed) or those chequer plate floor things. cheers the noo!
|
|
|
Post by stiltthewilt on Sept 19, 2011 12:31:09 GMT
Is this for a PK?
|
|
|
Post by scotia on Sept 19, 2011 20:06:30 GMT
no mate vrange , giong 12volt. does it matter?
|
|
|
Post by stiltthewilt on Sept 19, 2011 22:15:37 GMT
I had to make a special bracket for my 50 special as the PK one fouled on the inside of the engine side bubble... Sold the 50 spesh now tho
|
|
|
Post by scotia on Sept 19, 2011 23:04:52 GMT
okdave, thanks for that, i,ll see what i can come up with
|
|
|
Post by daisyb on Sept 20, 2011 6:41:56 GMT
Made one to take electronic coil in standard position that doesn't foul for my V range. If you can wait 'till friday I'll post pics & diagram.
|
|
|
Post by scotia on Sept 20, 2011 11:03:29 GMT
yup! that would be ideal-it aint goin anywhere just now.thank you
|
|
|
Post by scotia on Sept 27, 2011 22:21:37 GMT
still l :okin!
|
|
|
Post by daisyb on Sept 29, 2011 16:13:12 GMT
Sorry bruv, been working long hours. (an' I'm a builder - I didn't say WHICH friday!) Do it tomorrow.
|
|
|
Post by scotia on Sept 29, 2011 22:55:12 GMT
cheers mate. i,l put the kettle on. ;D
|
|
|
Post by daisyb on Oct 9, 2011 20:06:10 GMT
|
|
|
Post by scotia on Oct 12, 2011 21:36:56 GMT
cheers dave, did you draw round yours?? or is that a freehand geustimation?? i see that the hole positions and bend line state approx, but can i just print it out for the shape??
|
|
|
Post by daisyb on Oct 14, 2011 6:16:54 GMT
Yup, I drew round it. The "approximate" is because of the bend & the welded nuts it's difficult to get it exact on the tracing. Just print it off, allow 1mm for the pen line round the outline. Put it up against your casings/coil for the holes. Mess with the bend until it doesn't clump the panel/hit the spring on compressing the suspension. Shimples
|
|
|
Post by scotia on Oct 15, 2011 17:13:08 GMT
thank you sir you are a gentleman and a scholar
|
|