|
|
Post by steplce on Sept 2, 2011 6:16:47 GMT
ive got a 16/10 carb and i want to run a cylinder kit so i need a bigger carb or some bigger jets
|
|
|
|
Post by rhys on Sept 2, 2011 10:06:30 GMT
I have a 20mm delorto off an ets 125 on a two stud manifold you can have for £20 + postage.
|
|
|
|
Post by Rally 180 on Sept 2, 2011 11:02:22 GMT
Rhys, have send you a PM
|
|
|
|
Post by steplce on Sept 2, 2011 18:16:42 GMT
would it be ok for a 75cc kit, do you have the manifold, would i need to cut the side panel
|
|
|
|
Post by Rally 180 on Sept 2, 2011 20:48:28 GMT
Think a 20mm might be a bit big for 75 cc, 16 was used on the V90 and not saying that cause I need it lol, your 16 10 should be ok with a 75cc, but might need to adjust your jetting. Or I have a 16 16, although not too sure of the difference to a 16 10.
|
|
|
|
Post by Juan on Sept 2, 2011 20:57:03 GMT
I have a 20mm delorto off an ets 125 on a two stud manifold you can have for £20 + postage. The ETS inlet is about 4mm bigger than a 19/19 manifold so either it's a modified 3 stud manifold or a Malossi job with a 20/20 E carb. The ETS carb is a 20/20 L. |
|
|
|
Post by steplce on Sept 2, 2011 20:59:51 GMT
rally 180 pm'd
will a 16/16 carb fit my 16/10 manifold
|
|
