|
Post by Jimmy D on Aug 22, 2011 14:48:47 GMT
Hi all,
My clutch basket is rubbing, causing drag... think it's an aftermarket one that doesn't have the right clearance or something.
Does anyone have one that they know is 'ok'? Before I order a new one.
Thanks
|
|
|
Post by amazombi on Aug 22, 2011 15:17:57 GMT
The problem may not be the basket, but the christmass tree. The PK trees are quite a bit longer than the older ones.
|
|
|
Post by ttscshaggy on Aug 22, 2011 15:18:04 GMT
you dont have an xl2 clutch tho?
|
|
|
Post by Jimmy D on Aug 22, 2011 15:40:18 GMT
you dont have an xl2 clutch tho? Hmm, that's a very good point ;D managed to miss that bit, and the picture looked ideal for what I need.... one that's raised up a little. Ignore me....
|
|
|
Post by Jimmy D on Aug 22, 2011 15:42:43 GMT
The problem may not be the basket, but the christmass tree. The PK trees are quite a bit longer than the older ones. The christmas tree is original PK as far as I know... it just seems that when i tighten the clutch nut down it means the clutch basket rubs slightly. Not enough to cause it to lurch or stall but when I put it into first, even with the clutch in the revs drop slightly...
|
|
|
Post by ttscshaggy on Aug 22, 2011 15:51:27 GMT
Mathius , where can you get NOS xl2 xmas tree's ? Ive looked around the net and couldnt find anything I also measured a primmy and ETS xmas tree yesterday. The ETS one was only 0.2mm longer .FYI of-course
|
|
|
Post by Jimmy D on Aug 22, 2011 16:52:43 GMT
Mathius , where can you get NOS xl2 xmas tree's ? Ive looked around the net and couldnt find anything I also measured a primmy and ETS xmas tree yesterday. The ETS one was only 0.2mm longer .FYI of-course Mine's probably an ETS one, bearing in mind my engine is from a Spanish PK which seems to have the ETS needle bearing, ETS crank etc... hmm! Maybe i'll just take a dremel to the clutch basket!
|
|