|
Post by brash on Sept 30, 2010 14:57:39 GMT
Hi This is my setup for a Parmakit 130 centre plug version. The short forth with 26/69 and 8 spring clutch with Zirri selector are working well. Dyno results as follows: 128 main 55 pilot (mixture 1.5 turns out) AV264 Atomiser X3 needle on 2nd clip down All the slide,float,float needle etc is what came with the 30 mm Dellorto. The Parma 4TEX electronic ignition works best set on the 1st setting on this scoot.(Vespatronic would have probably done the same job) Hammerzombie Exhaust Standard Parma port timings with enlarged transfers by me ;D The green lines are power/Torque with X2 needle 2nd clip down.The red is Dyno corrected with X3 needle and 128 main.
|
|
|
Post by Perkin on Jul 5, 2011 15:46:02 GMT
Looks good; double the power of an ETS (fastest standard smallframe?) and not massive money.
What crank did you use?
Does the centre plug head make much difference to access? I assume you have to drop the engine to get to it...
|
|