|
|
Post by pinasco1978 on Oct 24, 2009 0:47:46 GMT
great reliable set up so far but it wont pull through from mid to top end, im not sure if its the exhaust or the jetting..
Can anyone give me a guide for a main jet with this set up (im on a 118):
177, delly24/24, pinasco exhaust.
|
|
|
|
Post by motovespa on Oct 28, 2009 15:54:34 GMT
a 118 main jet sounds about right, what gearbox are you using?
I've got pretty much the same setup and I'm running a P2 gearbox which is a bit tall but I'd imagine a 150 gearbox should be fine.
Cheers,
Rog
|
|
|
|
Post by MiNiKiN on Nov 6, 2009 17:57:40 GMT
sounds as if it leans out - - - does it idle normally when warm?
Just checked a mates P2 which had similar symptoms. It showed that the carb was lightly twisted and would not seal against the casing anymore. I personly would tighten the bolts rather to a max of 14 to 16Nm (16-20 are suggested in the manual) because these carbs seem to easily distort.
|
|
