|
Post by unreliablesc on Feb 20, 2007 21:24:25 GMT
Has anyone tried to fit an ET4 caliper to the 20mm grimeca classic kit? The ET4 has bigger pistons and pads...
I know i have to slot the holes in the calipers carrier 1mm towards center to make it fit, and i tiny bit of metal has to be removed from the hub.
But, I'm a lazy bastard, so if I don't have to disassemble the hub, I wont. What I'm to lazy to figure out my self, is how much to take off and where to take it.
can i remove any meat from the caliper itself?
Any opinions on this conversion at all?
|
|