|
Post by 225worb on Jul 8, 2009 20:55:16 GMT
Permed Haired Fella ...very polite ...i just call him Mr Sir Lauro .. No off the shelf pipe wil fit Mick because the exhaust flange/stud spaceing is wider ...Unless your going to get a pipe made i would suggest to go for the Hole Falc kit ... But as Tony said hes had his is adapted for race use so has been specialy set up for track use ....and would be a mental sprinter tooooo Im a slim 15 ( and a little ) stone and it pulls absoloutley crazily with moir on it ...
|
|
|
Post by MiNiKiN on Jul 9, 2009 9:28:08 GMT
exhaustwise you could as well go for the Scooter&Service Falcexhaust which kicks in a lot earlier and such adds to rideability (on the road).
|
|
|
Post by daveyluv on Jul 9, 2009 11:29:02 GMT
hi lads, i wish this thread was done earlier!! just got my casings back for my falc build and they are later pk 80 casings and they had the wrong flywheel bearing doh!! but now have had them redone to fit the earlier bearing (more expence) so now im going to need some help with the spec for the bits inside? i was going to use a 38mm mikuni power jet carb 4 speed gearbox with the zirri short 4th but not shore with the primeries exhaust etc??, what do you think?? i know there are a few of you out there using this kit so your advise would be greatly appprieciated !! so come on spill the beans!! ;D please!!
|
|