|
Post by panos08 on Oct 22, 2022 22:08:24 GMT
I recently bought a vmc tork s exhaust and everything was fine until I saw fuel leaking from the exhaust. I tried silicone but it didn't last long. Any advices?
|
|
|
Post by henri on Oct 23, 2022 6:56:52 GMT
exhaust assembly paste .
|
|
|
Post by panos08 on Oct 23, 2022 17:45:49 GMT
I tried and after a week same issue again. Maybe something like a tailpipe bandage?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Oct 23, 2022 19:14:32 GMT
K2 high temp sealant.
Cant stress enough - clean both surfaces until they shine like a sheeps arse. All previous sealant must be removed. Apply a generous amount of K2 to the male slip part. Once together run your finger round the joint to seal, fit spring, run finger round again. Leave overnight before starting. If it leaks after that I suspect a fitment/manufacturing error.
|
|
|
Post by panos08 on Nov 4, 2022 14:28:11 GMT
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Nov 5, 2022 10:09:20 GMT
Good to hear 👍 any high temp sealant is fine if I have found. Leaving it overnight is key I think 🤔 imagine the sealant all the way down in the slip joint, takes a while to completely cure and its not set hard by heating like exhaust paste.
|
|
|
Post by panos08 on Nov 6, 2022 22:03:16 GMT
The directions say 24 hours so I did. Let's se how long will it last. Next step if it doesn't work is exhaust seal tape.
|
|