|
Post by jonnysnatchsniffer on Sept 23, 2022 12:21:50 GMT
ok so i now have a set of cases that are bare, i have bar type gearchange, is there any benefit to having the round pk one, the bar type for me is just easier to use for cabling up, and while im at it where can i get the clutch cable adjuster bracket that actually lines up with the xl2 cover arm as i have 2, a short arm one and a pk long arm one and neither really point the right way the xl2 are is similar to the short arm but the xl2 has a larger ray davies than the short arm so sticks out further everyone just seem to have 1 in stock but its always listed for all the smallie models
|
|
|
Post by jonnysnatchsniffer on Sept 23, 2022 12:25:58 GMT
also are the gear change linkages inside the case the same for all models or is the xl2 one different? ive never really had much to do with xl2 motors so never compared side by side
|
|
|
Post by tzsteve on Sept 25, 2022 18:07:44 GMT
I think the cable ajusters are in the wrong place
|
|
|
Post by henri on Sept 26, 2022 9:25:58 GMT
xl2 cases are a single cable operation . inside the engine the forks same as pre xl2 engines . but the shaft through cases is totally different ,it runs in a needle bearing with a rotary shaft lip seal instead of having a o-ring . theres conversion kits to change it to twin cable operation . H
|
|
|
Post by jonnysnatchsniffer on Sept 26, 2022 19:47:34 GMT
yeah i can see that now as i looked in my vma1 cases not expecting anything to be in there the xl2 has a long bolt into the selector which has no links on the inside i suppose the wanky xl2 conversion to 2 cables that i had mimics the linkage but on the outside i never really took much notice as for the clutch adjuster, the vma1 with the short arm points in the right direction but is to close to the case so cable is on a bad angle, the pk one of which says its for pk and xl2 is ok for the pk long arm cover henri if i send you pics could you post them up so all can see the difference in all 3 different covers as its hard to explain i forgot how to post pics or i dont have whatever it is that host photosm and all that malarky
|
|
|
Post by henri on Sept 27, 2022 5:47:50 GMT
not a problem johnny ,send em on farcebook an i'll post em up .the xl2 cases are usually single bolt fitting cable brackets ,they line up the clutch cable as good as any types do .H
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 27, 2022 8:47:21 GMT
yeah i can see that now as i looked in my vma1 cases not expecting anything to be in there the xl2 has a long bolt into the selector which has no links on the inside i suppose the wanky xl2 conversion to 2 cables that i had mimics the linkage but on the outside i never really took much notice as for the clutch adjuster, the vma1 with the short arm points in the right direction but is to close to the case so cable is on a bad angle, the pk one of which says its for pk and xl2 is ok for the pk long arm cover henri if i send you pics could you post them up so all can see the difference in all 3 different covers as its hard to explain i forgot how to post pics or i dont have whatever it is that host photosm and all that malarky The XL2 cable converter isnt wanky 😂 with a bit of tweeking they are superb 😎
|
|