|
Post by rabbie65 on Apr 26, 2022 20:13:20 GMT
clutch on polini 130 4 plate, kickstart just goes straight down, engine does not turn over, took off clutch cover, and tried to undo clutch nut but just turns with shaft ? any ideas how to get clutch out ?
|
|
|
Post by henri on Apr 27, 2022 6:26:15 GMT
wedge the kickstart down to engage kickstart cog with the tree an try again ,or put it into gear an clamp the very end of output shaft in a vice . or fold up the tab washer so you can get a extractor onto the centre an with a big socket an the bolt compress clutch.pop out the circlip an plates ,release spring plate an remove spring .then try locking the centre with a bar through the tabs or a clutch locking tool an try to undo again .tho you might find the nut an shaft still turn as the centres slipped on the taper an done the key .H
|
|
|
Post by tzsteve on Apr 27, 2022 8:36:16 GMT
clutch on polini 130 4 plate, kickstart just goes straight down, engine does not turn over, took off clutch cover, and tried to undo clutch nut but just turns with shaft ? any ideas how to get clutch out ? That sounds like a cu¥¥t of a job
|
|
|
Post by gugne on Apr 27, 2022 15:22:28 GMT
what about using an impact gun?
|
|
|
Post by tzsteve on Apr 27, 2022 16:00:59 GMT
Likely hood is the sudden bang on the gears would dislodge a tooth or two from some part of the gears.
If the engine is getting a full strip and rebuild (which sounds likely) you could split the nut with a mini grinder. Just get all the swarf out of the engine
|
|
|
Post by henri on Apr 28, 2022 5:57:09 GMT
Likely hood is the sudden bang on the gears would dislodge a tooth or two from some part of the gears. If the engine is getting a full strip and rebuild (which sounds likely) you could split the nut with a mini grinder. Just get all the swarf out of the engine thats one i didnt think about ,drilling or splitting the nut .H
|
|
|
Post by tzsteve on Apr 28, 2022 8:10:46 GMT
Done it on other stuff cut along the slot that the w key sits is, can get messy so only the very last resort
|
|
|
Post by rabbie65 on Jun 24, 2022 15:16:17 GMT
clutch on polini 130 4 plate, kickstart just goes straight down, engine does not turn over, took off clutch cover, and tried to undo clutch nut but just turns with shaft ? any ideas how to get clutch out ? That sounds like a cu¥¥t of a job got it , held axle shaft with grips and used socket on nut , came off easy ! fitted new clutch centre and key, works great
|
|
|
Post by tzsteve on Jun 24, 2022 15:47:25 GMT
Life is a learning experience, Bet your relieved
|
|