|
Post by stusclues on Aug 26, 2019 1:53:38 GMT
As I've said a bunch of times, I have an M1L kit here (the type with the 6 bolt inlet manifold, whatever that makes it??) and I'm wondering if an XL2 clutch will handle the power? I'll be looking into using uprated springs (suggestions happily accepted) as well as some new plates (again with the suggestions...) as well as a 30mm PWK carb. (also open to using a different carb)
Would this work ok?
|
|
|
Post by madmax on Aug 28, 2019 18:44:12 GMT
According to some of the dyno graphs I have seen lately, the xl2 cover can handle up to 60 hp!
|
|
|
Post by tzsteve on Aug 29, 2019 19:56:44 GMT
I doubt that the plates or springs would take that
I did not know that the clutch cover had a limiting effect on the power that was going through the clutch
|
|