|
Post by cee on Nov 22, 2011 22:06:34 GMT
hello,
I am building a lambretta with a imola 185 kit.
for me it is important to keep the sidepanels and not to cut them, I dont want any holes for carbs,... in it, and I also want to use the toolbox.
So, I have tested it with the standard manifold and a phbh30mm carbu,,, no good, It will not fit between the sidepanels,
I probably need a special manifold made by LTH, but does anyone know which carbu I can best use to hold the toolbox?
|
|
|
Post by spiderwebb on Nov 23, 2011 5:50:54 GMT
|
|
|
Post by pascar on Dec 18, 2011 22:28:30 GMT
Hi,
You can use the MB developments short rubber mounted manifold which comes out at an angle. You can fit this under your panels and use it without an air filter (run it open-mouth) but you will need to take out your air filter box but you will be able to retain your toolbox. You can use your 30m Dellorto. I have fitted this to many scoots.
If you call MB Developments and ask for mouse and tell him excately what I have said he will send you the inlet manifold and rubber mount to suit.
Regards Steve
|
|