|
Post by mikea565 on Apr 19, 2008 20:53:35 GMT
New four plate clutch sitting in an RMS upgear clutch bell. When adjusted to its best ability the clutch drags but also takes loads of lever travel before fully engaging. Now I've used one of these sip 4 plates b4 in a standard piaggio clutch bell with no probs so is the RMS upgear clutch bell at fault.
|
|
|
Post by Juan on Apr 22, 2008 21:13:30 GMT
Not sure about the bell, I can't say I've noticed a difference with them.I've never had any joy with the RMS kits but I think it was Tony who pointed out it was likely to be coilbind with the spring that was the main culpirit.
|
|
|
Post by mikea565 on Apr 23, 2008 19:59:15 GMT
Cheers mate, I may try a taffy spring, when i can be arsed to buy one. 120 miles of easy riding to go and then to PM tuning for the dyno.
|
|