|
Post by unreliablesc on Dec 4, 2006 20:55:26 GMT
Where is the best place to start pulling through a new wiringloom? At the cutout for the brake lever, or under the seat? This is for a Primavera I'm building for my father over the winter, its stripped down except for the steering colum. Maybe I'll post it in the Projects thread if i remember to take some photos next time I'm over at his place. And while I'm one the electrics subject, I have a regulator of an Asian (Taiwan Vespa Co) PK100S , it has 4 connections (earth, G, G and A i think), not 3 like my other scooters has. Can i put it to use in this non battery PK ignition conversion? I'm guessing I can just drop the A slot and wire it as normal, but want to be sure.
|
|
|
Post by Juan on Dec 5, 2006 7:31:37 GMT
Ooh,wiring looms.............I bloody love that job. I feed string down through the frame,a bit tied onto the brake wires and then feed in from under the tank. As for the regulator,God only knows,those Oriental lot are a law unto themselves.The best I can sugguest is try it and see?
|
|
|
Post by barneystgeorge on Dec 5, 2006 10:50:46 GMT
tough job in garage today doing same i run 2 plastic cables down from headset 2 brake hole feed loom thru then tape cables to loom and pull throu make sure loom comes up right side of lock each half either side you need then to do same 4horn wires it is a pig of a job
|
|
|
Post by unreliablesc on Dec 5, 2006 13:19:37 GMT
thanks guys. It's shame how superior the largeframes are when it comes to installing a new loom...
|
|