roland87
Automatica
1981 50 Special
Posts: 1
|
Post by roland87 on Sept 9, 2021 21:50:12 GMT
|
|
|
Post by jonnysnatchsniffer on Sept 22, 2021 11:56:33 GMT
the vmc et7 135 looks interesting, nice big transfers and exhaust with 2 sub ports, dont know much about them tho, it looks like it would be the most powerfull depending on the port times you would need a proper expansion pipe for it id say and thats not cheap, the exhaust studs are further apart by 10mm than single exhaust port on the gsf it makes about 23-25ps which is metric hp so 21-22hp, it would put a smile on yr face for sure bus as you only have the polini pipe this kit is no good for you id use an alluminium kit if i were you so either the parmakits unless you go for the polini evo you will need a large taper crank with whatever you chose so hope yr ignition is for the 20mm taper
|
|
|
Post by tzsteve on Oct 2, 2021 22:51:55 GMT
nice looking as JSS says
thats also a 2 ring piston which suggests its not a rev monster but it looks like a bit of case work such as gasket face skimming might be needed for what`s in the kit i would say the price is very good
i cant help wondering what postage, vat, etc add to the cost
|
|