|
Post by mark on Mar 4, 2021 17:45:37 GMT
Evening All ( showing my age )
Thinking of treating myself to some new wheels.
Currently the usual 3.00 x 10 tyres on but a few of the better value deals are 3.50 x 10
I'm not sure but would the slightly wider tyre cause any issue other than clearing exhaust etc ?
Dixon
|
|
|
Tyre size
Mar 4, 2021 18:12:03 GMT
via mobile
Post by movin64 on Mar 4, 2021 18:12:03 GMT
Just stuck a 350 on my smallframe to see if it fits (front only) and all was ok, so I only think the exhaust clearance is what you need to think about 👍
|
|
|
Post by mark on Mar 4, 2021 19:25:01 GMT
Perfect Thanks I will check rear wheel / exhaust gap at weekend , I wouldn't have thought half an inch would be an issue.
|
|
|
Post by movin64 on Mar 5, 2021 6:13:27 GMT
Don't know if this will make a difference, but I am using a pk fork with px hub
|
|
|
Post by rhys on Mar 5, 2021 13:00:52 GMT
You may need to grind the side of the swing arm away a bit depending on how wide the tyre is your using
|
|
|
Post by tzsteve on Mar 5, 2021 21:24:52 GMT
they can be a little tight on the exhaust mount
|
|
|
Post by henri on Mar 6, 2021 15:52:38 GMT
as rhys an tz said . but it can all depend on the profile of which brand of tyre your going for . H
|
|
|
Post by mark on Mar 9, 2021 23:13:43 GMT
Thanks all
Didnt bother splashing out on a complete new set after all .
Just got a set of BGM rims for £45 , nothing fancy but seem good quality and stuck the old tubes / tyres on 3.00 x 10 as they had decent tread left.
The old ones weren't as bad as I thought when I took them off and cleaned off a bit of surface rust ( think one was yours Henri )
Anyway , I have a couple of spare rims if anybody in need . Maybe a coat of paint to " freshen up " for spring
Only done the front as its dark when I get back from work so will do the back at weekend.
Roll on spring !!!
|
|