|
Post by jellerby232 on May 10, 2020 10:56:44 GMT
Anybody have rough jetting for the Quattrini M200? Using M200 exhaust.
26mm VHST carb: Main jet 135-138 Idle jet 35-36 Atomizer HE 270 Needle D36 3d position from top Valve 50?
Found this, valve a 250?
|
|
|
Post by madmax on May 11, 2020 21:06:20 GMT
As per M200 instructions:
main jet 135-138 idle 35-36 atomizer HE270 needle D36 3d tack from the top slide 50 mix screw 2 turns out
Hope it helps
|
|
|
Post by jellerby232 on May 12, 2020 18:40:28 GMT
Thanks Max, do the VHST carbs not use a needle valve?
|
|
|
Post by madmax on May 12, 2020 18:48:40 GMT
They do but looks like the standard will do as there is no mention of changing it.
|
|
|
Post by jellerby232 on May 24, 2020 11:59:47 GMT
Thanks Max, ready to close casing now. I’m guessing they don’t use a case gasket and you just use sealant on casing? Smallframe and PX case gaskets don’t fit?
|
|
|
Post by tzsteve on May 24, 2020 16:02:05 GMT
I gave up on the gasket sets years ago. There are many good gasket goos to choose from. But I like yamabond the silver grey stuff
|
|
|
Post by madmax on May 24, 2020 21:13:56 GMT
Thanks Max, ready to close casing now. I’m guessing they don’t use a case gasket and you just use sealant on casing? Smallframe and PX case gaskets don’t fit? Quattrini casings don't use gaskets, quattrini suggest loctite 510 but any good sealant will do, threebond, yamabond etc...
|
|