|
Post by vespajcb on May 6, 2012 13:55:55 GMT
hi as anyone got any experiance with one of these exahusts they look really good and they fit with the toolbox in (well so it says), will be putting it on a polini with ports matched, polini reed valve 24mm carb, worb 5 crank, 27/69 primaries, parmakit ignition.
would i need a short 4th, and what carb setup (jets etc) thanks advance.
|
|
|
Post by jacques on May 6, 2012 20:06:40 GMT
Max has got one...
|
|
|
Post by vespajcb on May 7, 2012 19:41:19 GMT
HI Thanks for reply new to forum so don't now who max is sorry do you happen to know what he thinks ? thanks
|
|
|
Post by vesparep1 on May 8, 2012 16:31:29 GMT
HI Thanks for reply new to forum so don't now who max is sorry do you happen to know what he thinks ? thanks " dont no who max is ! " hes our little italian legend ! he will help ya mate, if not theres plenty of cleaver feckers on here to help , oh and welcome fella,
|
|
|
Post by madmax on May 8, 2012 17:37:27 GMT
Thanks for the nice introduction Russ. ;D Welcome to the forum vespajcb. The vsp road does fit the primmy. The only bad point is fitting the spring on the manifold (its a bit of a pain in the back side) as you can't lower the engine as the pipe goes under the floor boards. Its doable tho with a little patience. Also a short 4th will work better with your set up.
|
|
|
Post by vespajcb on May 8, 2012 20:55:51 GMT
hi thanks guys for the welcome thank you max for the info i will be ordering this pipe with a short 4th will post how i get on, can't wait ;D
|
|
|
Post by parts on May 17, 2012 20:30:24 GMT
You have to drop the engine to get it onto the manifold as the tool box gets in the way just let the pipe swing ounce it's on the manifold and the springs on raise the engine and then fix it up to the swing arm. It's a bit of a pain but worth it for how good it looks and sounds (my neighbours disagree but fuck um)
|
|