|
Post by smallframetony on Apr 25, 2011 21:25:48 GMT
ok wayne no rush would like to see a pic of the finished pipe too Good luck with it all mate ;D
|
|
|
Post by smallframetony on Sept 30, 2011 22:52:59 GMT
wayne you got a vid of it on the dyno ?
|
|
|
Post by Wayne Miller on May 30, 2012 22:35:01 GMT
Here you go MattBlack, use this as a reference, this is the old thread of my build he he he, Ive just looked at all of the weld I got built up by Martin the welder. You dont need half as much as I had done here. ;D
|
|
matteblack
Primavera
Cutdown Lambretta S1, Water cooled PX 177, Primmy project
Posts: 115
|
Post by matteblack on May 31, 2012 17:06:39 GMT
Cheers mate I'm on about page 12
|
|
|
Post by benjirixon on Jun 7, 2012 19:20:12 GMT
1st time ive seen this thread as only been here a few months. just read the whole thread........... incredible look no further than here for inspiration me thinks !
|
|
|
Post by Paul V on Oct 20, 2015 22:18:55 GMT
Just Joined and have a keen interest in Rotax 123/122 cylinders and such. Did you ever get this running right ?
|
|
|
Post by bc11avy1993 on Feb 4, 2016 21:49:19 GMT
Yes mate, If you look closely you can see that there mounted on Hose pipe for now Ive had some plastic bushes made but these will also have rubber in between them and the rads Ok.. you can buy off the shelf proper vibration resistant fasteners if you get stuck.
|
|
|
Post by bc11avy1993 on Feb 4, 2016 21:50:13 GMT
Yes mate, If you look closely you can see that there mounted on Hose pipe for now Ive had some plastic bushes made but these will also have rubber in between them and the rads Ok.. you can buy off the shelf proper vibration resistant fasteners if you get stuck.
|
|
|
Post by bc11avy1993 on Feb 4, 2016 21:53:20 GMT
I have the norrie rep seat to this bike me and a freind built it few years bak
|
|