|
Post by chopstik888 on Nov 21, 2019 15:19:29 GMT
Hi all...
Recently bought a PK125 on which the previous owner had bodged on a 24mm flat slide carb.
It was attached to the inlet manifold with a a cropped section of heavy rubber pipe and kept falling off... Anyway i want to put it back to the carb setup it should have had (SHB19/19).
Does anyone have a picture or a link to somewhere that does of how the carb is attached to the inlet manifold?
I’ve bought an Inlet Alloy Flange with an offset flange with finns on it. Is the off set lobe bit supposed to be off to one side as opposed to being at the top or bottom?
Haynes don’t do a manual and I’ve previously only had P ranges and T5’s so I know very little about small frames (not that I’m Professor Vespa on large frames either!!).
Thanks
|
|