|
Post by robert on Oct 3, 2019 9:11:44 GMT
What tool do you use for getting n1 in the picture out of engine flywheel side? Link to image
|
|
|
Post by tzsteve on Oct 3, 2019 15:03:38 GMT
ebay this is the type that you need a little heat will help. this set will also do the bigger 205 types and all the small case bearings it is normally possible to remove the mag bearing with plenty of heat and then banging the case against a block of wood but having the right tool is a big plus
|
|
|
Post by robert on Oct 11, 2019 18:50:54 GMT
Thanks a lot!
|
|
|
Post by 69shau on Oct 12, 2019 8:20:46 GMT
As above, 1, try heat/ gas gun and bang or use like an old chisel to tap into the edge and at least get it moving. 2, weld bit of metal bar or old bolt across, heat and tap out. 3, place the casing in the oven for 1/2 hr bang the case again should drop out.
|
|
|
Post by tzsteve on Oct 12, 2019 14:57:01 GMT
|
|