Crimaz push rod (for a lighter clutch pull)

[Kent Kurt]

Hi,

Has anyone here tried this to get a clutch pull lighter? 
Looking to fit on an ET3.

Thanks!


Crimaz push rod


<style></style>

[madmax]

Depend on what clutch you use. That will only work with clutches that have the bearing on the push plate.

[Kent Kurt]

Aug 14, 2019 18:56:10 GMT madmax said:

Depend on what clutch you use. That will only work with clutches that have the bearing on the push plate.

Thanks! I just had a DRT clutch installed (not by myself);
* 4 plates cork, 1.9mm for original clutch basket
* www.sip-scootershop.com/en/products/clutch+drt+sport+393211+for_40431812

If that one doesn't work out of the box perhaps I could install a new push plate, such as one of these?
www.sip-scootershop.com/en/products/pressure+plate+clutch+sip+_50050000
www.sip-scootershop.com/en/products/pressure+plate+clutch+crimaz+_50053200
www.sip-scootershop.com/en/products/pressure+plate+clutch+piaggio+_50051000

[Kent Kurt]

Has anyone else here installed the Crimaz geared push rod and would be willing to offer up advice?

[vespistazd]

I am also interested in this product...i have original 3 plate PK clutch in my PK and one reinforced spring and the clutc is very hard to deal with...